Back to section

NavArch Handbook

Chapter 5 / Section 5.13

Fishing vessel stability: Torremolinos/Cape Town and NMA requirements

International framework

  • Torremolinos International Convention for the Safety of Fishing Vessels, 1977, as modified by the 1993 Torremolinos Protocol and the 2012 Cape Town Agreement (not yet in force internationally as of 2026 — check status; applied regionally through EU Directive 97/70/EC and national regulations). Ch. III — Stability and associated seaworthiness.
  • IMO IS Code 2008, Part B, Ch. 2.1 — Fishing vessels: recommendatory criteria that reproduce the Torremolinos Ch. III criteria for decked vessels of 24 m and over; many Administrations apply them to smaller vessels too.
  • FAO/ILO/IMO Safety Recommendations for Decked Fishing Vessels of less than 12 m and Undecked Fishing Vessels (2012) and the Voluntary Guidelines for the Design, Construction and Equipment of Small Fishing Vessels (2005) for vessels 12–24 m.

Criteria for fishing vessels (IS Code Part B Ch. 2.1.3 / Torremolinos Ch. III Reg. 2)

Same as the general criteria of Part A Ch. 2.2 (areas 0.055 / 0.090 / 0.030 m·rad; GZ ≥ 0.20 m at ≥ 30°; φGZmax⁡\varphi_{GZ\max}φGZmax​ ≥ 25°) except:

  • GM0≥0.35GM_0 \ge 0.35GM0​≥0.35 m for single-deck vessels; for vessels with a complete superstructure, or vessels of 70 m and over, GM0GM_0GM0​ may be reduced to the satisfaction of the Administration but not below 0.15 m.
  • Severe wind and rolling criterion to be applied to vessels of 45 m and over (Ch. 2.1.4); for 24–45 m the Administration may apply it with a reduced wind pressure as a function of length (the Code gives a table of PPP against LLL: e.g. 316 Pa at 24 m rising to 504 Pa at 45 m — see Ch. 2.1.4.2).
  • Loading conditions to be examined (Ch. 2.1.2): departure for the fishing grounds with full fuel, stores, ice, gear; departure from the grounds with full catch; arrival at port with full catch and 10 % stores and fuel; arrival with 20 % of full catch and 10 % stores and fuel. Allowance for the weight of wet fishing nets and tackle on deck; icing per Part B Ch. 6.3.3 (fishing vessels: enhanced requirements for certain areas — Administrations such as Norway require higher ice loads in northern waters).
  • Water on deck (Ch. 2.1.5 / Torremolinos Ch. III Reg. 2(1)(d)): for vessels with a well deck, the Administration may require assessment of the effect of water trapped on deck (the Code gives a method for vessels 24–45 m in Ch. 2.1.5 and Annex).
  • Beam trawlers (Ch. 2.1.6): increased criteria — GM0≥0.50GM_0 \ge 0.50GM0​≥0.50 m for beam trawlers (Administration), and the general area criteria increased by 20 %.

Norwegian Maritime Authority (Sjøfartsdirektoratet)

Norwegian fishing vessels are regulated nationally:

  • Forskrift om bygging og tilsyn av fiske- og fangstfartøy med største lengde på 15 meter og derover (Regulation on construction and supervision of fishing vessels of 15 m length overall and over), FOR-2000-02-15 No. 158 (as amended) for vessels ≥ 15 m — it implements Torremolinos / Directive 97/70/EC for ≥ 24 m and sets national stability requirements for 15–24 m (Ch. 3 stability) including the IS Code criteria with GM ≥ 0.35 m, icing requirements, water on deck, and criteria for specific fishing methods (purse seining with heavy gear, trawling with towing-force heeling moment).
  • Forskrift om fiske- og fangstfartøy under 15 meter største lengde (FOR-2013-11-22 No. 1404) for vessels 6–15 m: stability according to the Nordic Boat Standard (1990) Ch. Y (stability) or ISO 12217-1 for the smallest; includes requirements for a stability guide ("stabilitetsveiledning") on board.
  • NMA circulars (RSV) and the "Stabilitetsplakat" (stability poster) requirement. These regulations are updated frequently; the current consolidated text is on lovdata.no (Norwegian) and partly in English on sdir.no. Confirm the edition in force for the vessel's build contract and keel-laying date.

Fishing-method specific heeling levers (practice)

  • Trawling: heeling moment from the warp tension at the gallows/blocks: Mh=Fw×zM_h = F_w \times zMh​=Fw​×z (towing force × vertical lever from the propeller thrust line or from the centre of lateral resistance); criterion often "heel ≤ deck-edge immersion / 10°" and residual area.
  • Purse seining: heeling from the net and catch hauled over the side (power block), plus crew and gear on one side.
  • Catch in RSW tanks: large free-surface moments; subdivision of tanks and pressing up are essential; the IS Code Part B Ch. 2.1.2.5 requires the actual free-surface effect of partially filled fish holds to be considered.

Formulas

01Minimum GM for fishing vessels
GM0≥0.35 m (single-deck);GM0≥0.15 m (complete superstructure or L≥70 m, with Administration’s agreement)GM_0 \ge 0.35\ \text{m (single-deck)}; \qquad GM_0 \ge 0.15\ \text{m (complete superstructure or } L \ge 70\ \text{m, with Administration's agreement)}GM0​≥0.35 m (single-deck);GM0​≥0.15 m (complete superstructure or L≥70 m, with Administration’s agreement)

Result unit m

IS Code 2008 Part B Ch. 2.1.3.4; Torremolinos Ch. III Reg. 2(1)(c).

02Reduced wind pressure for 24–45 m fishing vessels (weather criterion)
P(L)≈316+504−31645−24 (L−24)  Pa,24≤L≤45 mP(L) \approx 316 + \frac{504 - 316}{45 - 24}\,(L - 24) \ \ \text{Pa}, \quad 24 \le L \le 45\ \text{m}P(L)≈316+45−24504−316​(L−24)  Pa,24≤L≤45 m
SymbolDescriptionUnit
LLLLength of the vesselm

Result unit Pa

Linear fit to the IS Code Part B Ch. 2.1.4.2 table; use the table values themselves for compliance.

03Trawl warp heeling moment (simplified)
Mh=Fw zw,lh=MhΔgM_h = F_w\, z_w, \qquad l_h = \frac{M_h}{\Delta g}Mh​=Fw​zw​,lh​=ΔgMh​​
SymbolDescriptionUnit
FwF_wFw​Transverse component of the warp tension (often taken as the bollard pull or a fraction of it)kN
zwz_wzw​Vertical distance from the warp block to the centre of lateral underwater resistance (≈ T/2)m

Result unit kN·m

National regulations (e.g. NMA) define the force to use; confirm with the Administration.

Tables

Fishing vessel intact stability criteria compared (IS Code Part B 2.1 / Torremolinos Ch. III vs general Part A 2.2)

CriterionGeneral ships (Part A 2.2)Fishing vessels (Part B 2.1 / Torremolinos III/2)Beam trawlers (Part B 2.1.6)
Area 0–30°≥ 0.055 m·rad≥ 0.055 m·rad≥ 0.066 m·rad (+20 %)
Area 0–40° (or φf)≥ 0.090 m·rad≥ 0.090 m·rad≥ 0.108 m·rad
Area 30–40°≥ 0.030 m·rad≥ 0.030 m·rad≥ 0.036 m·rad
GZ at ≥ 30°≥ 0.20 m≥ 0.20 m≥ 0.20 m
Angle of GZmax≥ 25°≥ 25°≥ 25°
GM0≥ 0.15 m≥ 0.35 m single deck; ≥ 0.15 m complete superstructure / L ≥ 70 m≥ 0.50 m
Weather criterionAll ships ≥ 24 m≥ 45 m (24–45 m: Administration, reduced P)as fishing vessels
Loading conditionsPer bookletFour specified fishing conditions + icing + wet gearas fishing vessels
Source: IMO IS Code 2008 Part B Ch. 2.1; Torremolinos Protocol 1993 / Cape Town Agreement 2012 Ch. III Reg. 2; EU Directive 97/70/EC Annex.

Norwegian regulatory map for fishing vessel stability

Vessel length (LOA)Regulation (short name)Stability basis
< 6 mNot subject to construction regulation (safety equipment rules apply)—
6–15 mForskrift om fiske- og fangstfartøy under 15 m (FOR-2013-11-22-1404)Nordic Boat Standard 1990 / ISO 12217-1; stability guide on board
15–24 mForskrift om bygging og tilsyn av fiske- og fangstfartøy ≥ 15 m (FOR-2000-02-15-158), Ch. 3IS Code criteria with GM ≥ 0.35 m, icing, water on deck, method-specific heeling moments
≥ 24 mSame regulation implementing Torremolinos 1993 / Directive 97/70/ECTorremolinos Ch. III; weather criterion ≥ 45 m
Source: Norwegian Maritime Authority (Sjøfartsdirektoratet) regulations as published on lovdata.no. Confirm the current consolidated versions — the regulations are amended frequently.

Examples

#01

GM check of a 28 m stern trawler in the arrival condition

Worked example

Problem

A single-deck stern trawler, L=28L = 28L=28 m, in the arrival condition (full catch, 10 % stores and fuel) has Δ=438\Delta = 438Δ=438 t, KM=4.62KM = 4.62KM=4.62 m, solid KG=4.05KG = 4.05KG=4.05 m, and slack tanks with total FSM of 48 t·m. Icing adds 12 t at Kg=7.5Kg = 7.5Kg=7.5 m (weather deck 30 kg/m² and lateral area). Check GM0GM_0GM0​ against the fishing vessel criterion.

Solution

Without icing: GGv=48/438=0.110GG_v = 48/438 = 0.110GGv​=48/438=0.110 m; GMf=4.62−4.05−0.110=0.46GM_f = 4.62 - 4.05 - 0.110 = 0.46GMf​=4.62−4.05−0.110=0.46 m ≥ 0.35 m — pass.

With icing: KG′=438×4.05+12×7.5450=1773.9+90450=4.142KG' = \dfrac{438 \times 4.05 + 12 \times 7.5}{450} = \dfrac{1773.9 + 90}{450} = 4.142KG′=450438×4.05+12×7.5​=4501773.9+90​=4.142 m; KMKMKM at 450 t ≈ 4.60 m; GGv=48/450=0.107GG_v = 48/450 = 0.107GGv​=48/450=0.107 m; GMf=4.60−4.142−0.107=0.35GM_f = 4.60 - 4.142 - 0.107 = 0.35GMf​=4.60−4.142−0.107=0.35 m — marginal pass (exactly at the limit). The full GZ-curve criteria and the water-on-deck assessment must be checked for this condition; in practice the designer would add low ballast or reduce the permitted deck load in icing conditions.

References

IMO IS Code 2008Clause Part B, Ch. 2.1 (Fishing vessels), Ch. 6.3.3 (Icing — fishing vessels)Recommended

Applied as mandatory through Torremolinos/Directive 97/70/EC and national regulations.

Torremolinos Protocol 1993 / Cape Town Agreement 2012Clause Ch. III, Reg. 2 (Stability criteria), Reg. 3 (Flooding of fish holds), Reg. 7 (Operating conditions), Reg. 8 (Ice accretion)Mandatory

Mandatory in the EU via Directive 97/70/EC for vessels ≥ 24 m; Cape Town Agreement entry into force — check current status.

Norwegian Maritime Authority — FOR-2000-02-15 nr 158 (fishing vessels ≥ 15 m) and FOR-2013-11-22 nr 1404 (fishing vessels < 15 m)Clause Stability chaptersMandatory

Norwegian flag. Current text on lovdata.no.

Nordic Boat Standard 1990 (Nordisk Båtstandard for yrkesbåter under 15 m)Clause Section Y (Stability and buoyancy)Mandatory

Where referenced by national regulation (Norway, Denmark, Sweden, Finland, Iceland).