NavArch Handbook
Chapter 1 / Section 1.4
For a plane area with coordinates :
where is about the centroidal axis and the distance between the parallel axes. The centroidal second moment is always the minimum. This theorem is the basis of every built-up section calculation (Section 2.5) and of the waterplane inertia about the LCF (Section 4.6).
Holes are included as negative areas. In ship sections, the table is usually built about the baseline and then shifted to the neutral axis with (Section 7.3).
Principal axes: ; for symmetric ship sections the centreline and the horizontal neutral axis are principal. Unsymmetrical stiffeners (angles, bulb flats) bend about a principal axis inclined to the plate; the rule section modulus is nevertheless computed about the axis parallel to the plate (Section 2.5) because the plate restrains the stiffener.
See the table. The waterplane and section results used in hydrostatics (rectangle, triangle, semi-ellipse, parabola) are included because they give quick checks for barge-shaped hulls and for waterplane coefficients.
| Symbol | Description | Unit |
|---|---|---|
| Centroid coordinate | m | |
| Area of part i | m² | |
| Centroid of part i | m |
Result unit m
| Symbol | Description | Unit |
|---|---|---|
| Second moment about the x-axis | m⁴ | |
| Distance from the x-axis | m |
Result unit m⁴
| Symbol | Description | Unit |
|---|---|---|
| Second moment about the centroidal axis | m⁴ | |
| Distance between the two parallel axes | m |
Result unit m⁴
| Symbol | Description | Unit |
|---|---|---|
| Second moment about the reference (base) line | m⁴ |
Result unit m⁴
Result unit m⁴, m
| Symbol | Description | Unit |
|---|---|---|
| Product of inertia | m⁴ | |
| Angle of the principal axis from the x-axis | rad |
Result unit m⁴
| Figure | Area | Centroid (from base) | about horizontal centroidal axis | about base |
|---|---|---|---|---|
| Rectangle b × h | ||||
| Triangle, base b, height h | ||||
| Trapezoid, parallel sides a (top), b (bottom), height h | — | |||
| Circle, diameter d | — | |||
| Hollow circle, d_o, d_i | — | |||
| Thin ring, mean radius r, thickness t | — | |||
| Semicircle, radius r (flat side as base) | ||||
| Ellipse, semi-axes a (horizontal), b (vertical) | — | |||
| Parabolic segment, base b, height h (vertex at top) | ||||
| Rectangular waterplane L × B about centreline | — | — | ||
| Triangular waterplane end, length ℓ, full base B, about its axis of symmetry | from base | — |
Worked example
Problem
A barge waterplane consists of a rectangle 40 m long × 12 m wide (stern end at x = 0) and an isosceles triangular bow of length 10 m on the full 12 m base. Find the waterplane area, the LCF from the stern, and about the centreline.
Solution
Areas: rectangle m²; triangle m². m².
Centroids from the stern: rectangle 20 m; triangle m.
about the centreline (an axis of symmetry for both parts, so no parallel-axis terms):
For a draught of 2.0 m and m³ (allowing for the bow taper below the waterline), m — the typical very large metacentric radius of a shallow barge.