Chapter 5 / Section 5.12
Damage stability fundamentals: lost buoyancy vs added weight, permeability
Two equivalent methods
When a compartment is opened to the sea, the final equilibrium can be computed in two ways:
Added weight (added mass) method — the flood water is treated as a mass added to the ship. Displacement increases; changes; the free surface of the flood water is a free-surface effect; is taken at the new displacement. The ship sinks and trims until the new equals the buoyancy of the intact hull at the new waterline including the damaged compartment up to the new waterline — an iteration is needed because the flood water depends on the final waterline.
Lost buoyancy (constant displacement) method — the damaged compartment is considered no longer part of the ship. Displacement and are unchanged; the ship loses the buoyancy of the flooded volume and the waterplane area of the compartment; the remaining intact volume must sink until the lost buoyancy is regained. , and are those of the damaged hull (reduced waterplane). No free surface correction (the water is not "on board").
Both give the same final draughts, trim and heel. The intermediate quantities (, ) differ, so never mix the two methods. Classification and SOLAS software use the lost buoyancy method; hand calculations of a box barge are easiest by lost buoyancy.
Lost buoyancy procedure (box-shaped compartment, no trim)
- Volume lost: (compartment length , breadth , permeability ).
- Intact waterplane after damage: .
- Sinkage: .
- New , new of the intact waterplane (subtract the compartment's second moment, including its own parallel-axis term if off-centre), new , , (KG unchanged).
- Off-centre compartment: heeling moment from the shift of the centre of buoyancy; heel (small angles).
Permeability
The fraction of a compartment's volume that can be occupied by flood water. SOLAS Ch. II-1 Reg. 7-3 values are tabulated below; for probabilistic damage stability the cargo space permeabilities depend on the draught considered (, , ).
Regulatory framework (overview)
- SOLAS Ch. II-1, Part B-1 — probabilistic damage stability (attained index required index ) for passenger ships and cargo ships ≥ 80 m (as amended 2009, 2020).
- Deterministic damage stability still applies to specific types: ICLL 1988 Reg. 27 (type A and reduced-freeboard type B ships), MARPOL Annex I (tankers), IBC/IGC Codes, SPS Code 2008 (special purpose ships), MODU Code, and OSV Guidelines (Res. MSC.235(82) as amended by MSC.335(90)) — which is the route for most offshore supply vessels.
- Fishing vessels — Torremolinos/Cape Town Agreement requires damage stability only for vessels ≥ 100 m (Ch. III Reg. 2(5)) unless the Administration requires more; NMA regulations may add requirements.
- Survival criteria after damage (deterministic, typical): final waterline below the margin line / openings; final heel ≤ 15°–17° (SPS: 15°), residual m, residual GZ range ≥ 15°–20° with area ≥ 0.015 m·rad and m (passenger-ship type criteria; OSV Guidelines Ch. 3) — always take the exact figures from the governing instrument.
Formulas
| Symbol | Description | Unit |
|---|---|---|
| Permeability | - | |
| Length and breadth of the flooded compartment | m | |
| Initial draught | m | |
| Intact waterplane area before damage | m^2 |
Result unit m
| Symbol | Description | Unit |
|---|---|---|
| Transverse distance of compartment centroid from centreline | m | |
| Displacement volume (unchanged) | m^3 |
Result unit m
KG is unchanged in the lost-buoyancy method.
| Symbol | Description | Unit |
|---|---|---|
| Volume of flood water (to the final waterline) | m^3 | |
| Height of the centroid of the flood water | m |
Result unit m
Then subtract the free-surface effect of the flood water and use KM at Δ + ρv. Iterate on the final waterline.
Result unit deg
| Symbol | Description | Unit |
|---|---|---|
| Maximum compartment length centred at x that can be flooded without immersing the margin line | m |
Result unit m
Conceptual; the floodable length curve is produced by the stability software (Shirokauer method in older texts).
Tables
Permeability values (SOLAS Ch. II-1, Reg. 7-3)
| Space | Permeability |
|---|---|
| Appropriated to stores | 0.60 |
| Occupied by accommodation | 0.95 |
| Occupied by machinery | 0.85 |
| Void spaces | 0.95 |
| Intended for liquids | 0 or 0.95, whichever gives the more severe requirement |
| Dry cargo spaces (at / / ) | 0.70 / 0.80 / 0.95 |
| Container spaces (at / / ) | 0.70 / 0.80 / 0.95 |
| Ro-ro spaces (at / / ) | 0.90 / 0.90 / 0.95 |
| Cargo liquids (at / / ) | 0.70 / 0.80 / 0.95 |
Examples
Flooding of a box barge — lost buoyancy method
Worked example
Problem
A box-shaped barge m, m floats at m in seawater with m. A midship compartment 10 m long, full breadth, permeability 0.85, is bilged (flooded to the sea). Find the new draught and GM.
References
Applied as mandatory by most flag states (incl. Norway) for OSVs.
Version 2 · last updated 19 Nov 2026 · Editor