NavArchHandbook0 ch

No chapters yet.

Engineering tools
NavArchHandbook
NavArchHandbook
↵
BookmarksTools
Home›5. Stability›5.9 List due to transverse weight shift and added weights

Chapter 5 / Section 5.9

List due to transverse weight shift and added weights

Print this section

List vs heel

List is a steady inclination caused by an off-centre centre of gravity (or an asymmetric buoyancy after damage). Heel is an inclination caused by an external moment (wind, turning, towline). The calculation of the list angle is the same; the distinction matters for the stability criteria, which treat them differently.

Transverse shift of a mass

Moving www a distance ddd across the ship moves GGG by GGh=w d/ΔGG_h = w\,d/\DeltaGGh​=wd/Δ. The ship lists until GGG is again vertically below MMM:

tan⁡θ=GGhGM=w dΔ GM\tan\theta = \frac{GG_h}{GM} = \frac{w\,d}{\Delta\,GM}tanθ=GMGGh​​=ΔGMwd​

Valid for small angles (metacentric method, roughly θ<10°\theta < 10°θ<10°). For larger lists use the GZ curve: the list is where GZ(θ)=GGhcos⁡θGZ(\theta) = GG_h\cos\thetaGZ(θ)=GGh​cosθ (Section 5.4).

Adding a mass off-centre

  1. New displacement Δ′=Δ+w\Delta' = \Delta + wΔ′=Δ+w; new KG′=(Δ KG+w Kg)/Δ′KG' = (\Delta\,KG + w\,Kg)/\Delta'KG′=(ΔKG+wKg)/Δ′; new KM′KM'KM′ from hydrostatics at Δ′\Delta'Δ′; GM′=KM′−KG′GM' = KM' - KG'GM′=KM′−KG′.
  2. Transverse moment w yw\,ywy (yyy = off-centre distance): tan⁡θ=w yΔ′ GM′\tan\theta = \dfrac{w\,y}{\Delta'\,GM'}tanθ=Δ′GM′wy​. Several masses: sum the transverse moments (port negative, starboard positive) and use the resultant.

Correcting a list

To bring the ship upright, a transverse moment equal and opposite to the listing moment is required: wballast yballast=Δ GGhw_{\text{ballast}}\,y_{\text{ballast}} = \Delta\,GG_hwballast​yballast​=ΔGGh​. Always check that the added ballast does not reduce GMGMGM (fill low tanks) and that the correction does not create a free surface problem.

Draughts of a listed ship

At list θ\thetaθ, the draught at the low side increases by approximately B2sin⁡θ\tfrac{B}{2}\sin\theta2B​sinθ relative to the centreline draught (which itself changes slightly because the heeled waterplane area differs).

Angle of loll vs list

If the ship lists with a negative GM, the metacentric formula gives no meaningful result; the ship is at loll (Section 5.1). Diagnose by rolling behaviour (sluggish, hanging at the angle, flopping to the other side) before taking corrective action.

Formulas

01List from a transverse shift of mass
tan⁡θ=w dΔ GM\tan\theta = \frac{w\, d}{\Delta\, GM}tanθ=ΔGMwd​
SymbolDescriptionUnit
θ\thetaθAngle of listdeg
wwwMass shiftedt
dddTransverse distance shiftedm
GMGMGMFluid metacentric heightm

Result unit deg

Small angles (< ~10°). Use the GZ curve for larger lists.

02List from an added off-centre mass
tan⁡θ=w y(Δ+w) GM′,GM′=KM′−Δ KG+w KgΔ+w\tan\theta = \frac{w\, y}{(\Delta + w)\, GM'}, \qquad GM' = KM' - \frac{\Delta\,KG + w\,Kg}{\Delta + w}tanθ=(Δ+w)GM′wy​,GM′=KM′−Δ+wΔKG+wKg​
SymbolDescriptionUnit
yyyTransverse distance of the added mass from centrelinem
KM′KM'KM′KM at the new displacementm

Result unit deg

03List at large angles
GZ(θ)=GGhcos⁡θ⇒θGZ(\theta) = GG_h\cos\theta \quad\Rightarrow\quad \thetaGZ(θ)=GGh​cosθ⇒θ
SymbolDescriptionUnit
GGhGG_hGGh​Transverse offset of Gm

Result unit deg

Solve graphically or numerically; GG_h cos θ is the 'heeling lever' curve of the off-centre G.

04Ballast to correct a list
wb yb=Δ GGhw_b\, y_b = \Delta\, GG_hwb​yb​=ΔGGh​
SymbolDescriptionUnit
wbw_bwb​Ballast masst
yby_byb​Transverse position of ballast (opposite side)m

Result unit t·m

05Increase of draught on the low side
δTlow≈B2sin⁡θ\delta T_{\text{low}} \approx \frac{B}{2}\sin\thetaδTlow​≈2B​sinθ

Result unit m

Examples

#01

List from a transverse shift

Worked example

Problem

Example vessel: Δ=6314\Delta = 6314Δ=6314 t, fluid GM=0.70GM = 0.70GM=0.70 m, B=16B = 16B=16 m. A 50 t container is shifted 8.0 m to starboard. Find the list and the increase of draught on the starboard side.

Solution

tan⁡θ=50×8.06314×0.70=4004420=0.0905⇒θ=5.2° to starboard\tan\theta = \frac{50 \times 8.0}{6314 \times 0.70} = \frac{400}{4420} = 0.0905 \quad\Rightarrow\quad \theta = 5.2°\ \text{to starboard}tanθ=6314×0.7050×8.0​=4420400​=0.0905⇒θ=5.2° to starboard

Increase of draught starboard: ≈8.0sin⁡5.2°=0.72\approx 8.0\sin 5.2° = 0.72≈8.0sin5.2°=0.72 m. A list of 5° is small enough for the metacentric method; the GZ-curve check gives GGh=400/6314=0.063GG_h = 400/6314 = 0.063GGh​=400/6314=0.063 m and GZ(5.2°)≈0.70×sin⁡5.2°=0.063GZ(5.2°) \approx 0.70 \times \sin 5.2° = 0.063GZ(5.2°)≈0.70×sin5.2°=0.063 m — consistent.

#02

Loading an off-centre mass and correcting the list

Worked example

Problem

The vessel at Δ=6314\Delta = 6314Δ=6314 t, KGf=5.28KG_f = 5.28KGf​=5.28 m, KM=5.98KM = 5.98KM=5.98 m loads a 120 t module on deck at Kg=10.5Kg = 10.5Kg=10.5 m, 4.0 m to port. KMKMKM at 6434 t is 5.95 m. Find the list and the seawater ballast required in a wing tank 6.0 m to starboard (tank centroid Kg=1.2Kg = 1.2Kg=1.2 m) to bring the ship upright.

Solution

New KG: KG′=6314×5.28+120×10.56434=33,338+12606434=5.377KG' = \dfrac{6314 \times 5.28 + 120 \times 10.5}{6434} = \dfrac{33{,}338 + 1260}{6434} = 5.377KG′=64346314×5.28+120×10.5​=643433,338+1260​=5.377 m. GM′=5.95−5.377=0.573GM' = 5.95 - 5.377 = 0.573GM′=5.95−5.377=0.573 m.

List: tan⁡θ=120×4.06434×0.573=4803687=0.130⇒θ=7.4°\tan\theta = \dfrac{120 \times 4.0}{6434 \times 0.573} = \dfrac{480}{3687} = 0.130 \Rightarrow \theta = 7.4°tanθ=6434×0.573120×4.0​=3687480​=0.130⇒θ=7.4° to port.

Ballast to correct: wb×6.0=480⇒wb=80w_b \times 6.0 = 480 \Rightarrow w_b = 80wb​×6.0=480⇒wb​=80 t to starboard.

Effect on GM: KG′′=6434×5.377+80×1.26514=34,596+966514=5.326KG'' = \dfrac{6434 \times 5.377 + 80 \times 1.2}{6514} = \dfrac{34{,}596 + 96}{6514} = 5.326KG′′=65146434×5.377+80×1.2​=651434,596+96​=5.326 m; with KM≈5.94KM \approx 5.94KM≈5.94 m at 6514 t, GM′′=0.61GM'' = 0.61GM′′=0.61 m — the low ballast improves GM by about 4 cm. Add the free surface moment of the ballast tank if it is not pressed full.

References

Barrass & Derrett (2012)Clause Ch. 21 (List) and Ch. 25 (Combined list and trim)Textbook
IMO IS Code 2008Clause Part B, Ch. 2.9 (Lifting operations — heel limits) and Ch. 3.1.2 (Passenger ships — crowding and turning heel limits)Recommended
Previous · 5.8Longitudinal stability and trimNext · 5.10Heavy-lift operations and suspended weights

Version 2 · last updated 19 Nov 2026 · Editor

On this page

  • List vs heel
  • Transverse shift of a mass
  • Adding a mass off-centre
  • Correcting a list
  • Draughts of a listed ship
  • Angle of loll vs list
  • Formulas
  • Examples
  • References

Applicable standards

  • Barrass & Derrett (2012)

    Ch. 21 (List) and Ch. 25 (Combined list and trim)

  • IMO IS Code 2008

    Part B, Ch. 2.9 (Lifting operations — heel limits) and Ch. 3.1.2 (Passenger ships — crowding and turning heel limits)

NavArch Handbook·About & disclaimerFeedbackBookmarks© Jadrija Maritime j.d.o.o.