Chapter 4 / Section 4.2
Lines plan, body plan and offsets
The lines plan
The lines plan defines the moulded hull surface by three orthogonal sets of sections:
- Body plan — transverse sections (stations) projected on the midship plane. By convention, forward stations are drawn on the right-hand side and aft stations on the left.
- Sheer plan (profile) — buttock lines (vertical longitudinal planes parallel to CL) and the profile of stem, stern, deck at side and keel.
- Half-breadth plan — waterlines (horizontal planes) drawn for one side of the ship.
Diagonals are added to check fairness, particularly at the turn of bilge.
Table of offsets
The hull surface is tabulated as half-breadths [m] at each station and each waterline, together with heights of deck at side, deck at centre, and the keel/rabbet line. Offsets are given to the moulded surface (inside of shell plating for steel; outside of hull for GRP, by convention of ISO 8666 for small craft — check which surface is used).
A typical set for hydrostatic integration uses:
- 11 or 21 stations (0 = AP, 10 or 20 = FP), with half-stations near the ends where the curvature is high;
- waterlines at equal spacing (e.g. every 0.5 m or 1.0 m) from baseline to the design or scantling waterline, plus intermediate waterlines near the baseline.
Fairing
A fair hull has smooth, continuous curvature in all three views. In manual fairing the three plans are iterated until every point agrees in all projections. In CAD (NURBS surfaces) fairness is checked with curvature combs and zebra stripes. Offsets used for hydrostatics must be taken from the faired surface.
Appendages
Rudder, propeller, shaft bossings, bilge keels, skegs and sea chests are not part of the moulded hull. Their volume is added separately as the appendage allowance when computing displacement (typically 0.5–2 % of moulded volume depending on ship type).
Coordinate system (recommended for the handbook and for CAD exchange)
- positive forward, origin at AP (or at midship — state which);
- positive to port (ISO 7462) — note that some software uses starboard positive;
- positive upward, origin at baseline. Always state the origin and sign convention on every hydrostatic table and drawing.
Formulas
| Symbol | Description | Unit |
|---|---|---|
| Total immersed volume | m^3 | |
| Moulded volume from offsets | m^3 | |
| Shell plating allowance (steel: 0.005–0.008) | - | |
| Volume of appendages (rudder, bossings, bilge keels, etc.) | m^3 |
Result unit m^3
The shell allowance is approximately S_wet × t_shell for the immersed shell.
Tables
Typical appendage allowances (percent of moulded displacement volume)
| Ship type | Allowance % | Main contributors |
|---|---|---|
| Single-screw cargo ship | 0.5–1.0 | Shell plating, rudder, bilge keels |
| Twin-screw ship with bossings/brackets | 1.0–2.0 | Shell, shaft bossings, brackets, rudders |
| Fishing vessel with nozzle and large skeg | 1.5–2.5 | Skeg, nozzle, rudder, shell |
| GRP small craft (offsets to outside of hull) | 0.2–0.8 | Keel, rudder, skeg (no shell allowance) |
References
Defines coordinate axes and dimension terminology for data exchange.
Dimension definitions for craft under 24 m (used by ISO 12215/12217 and the RCD).
Version 2 · last updated 19 Nov 2026 · Editor